Hi, this is my first proper post, and I will explain, in words and photos, how to make loops for earrings.
You will need - your choice of beads, headpins, a pair of earwires, round nose pliers, and pliers to cut metal (nail clippers will also do this job, but they will wear out more quickly!).
First, thread your beads onto the headpin, and cut the
headpin so that you have about 1cm of wire above the beads.
With the tip of the round nose pliers, grip the wire where it
comes out of the top bead, as close as you can to the beads, and bend it over to an angle of about 45 degrees.
Now grip the top of the wire with the
round nose pliers. Any wire that is sticking up out of the pliers will remain straight, so just run your finger along the pliers to make sure that the wire is sitting in the centre of the
pliers. You should not be able to feel the tip of the wire.
Rotate the pliers towards the beads, so that the
wire curves around them. You need to keep the wire hugging the pliers to form a nice circle. I find it helps to rest the wire on the index finger of my left hand (I am right handed) and hold it in place with my thumb. About half way round, you will need to slacken the
pliers and reposition them to continue.
When the tip of the wire meets the start of the
loop, your loop is complete. It should be sitting centrally above the beads,
and there should be no gap where the wires meet. If not, don't worry, you will perfect this skill with practice.
Your earring will fit onto any standard earwire so long as there is a loop to hang it onto.
Next time - How to make even sized loops every time.